vehicle setup ride height vs. cross weight

Repeat this as many times as needed until ride height is achieved. Using the notes made when the vehicle was on the ground, make the appropriate adjustments and set it down on the ground again. This means you may have to adjust the collars a few times before it is dialed exactly where you want it. We’re often very close but typically need to do minor adjusting after the initial setting to get it perfect. We have been doing this for years and I could probably count on one hand how many times we nail ride height on the first try. From there you can get an idea if you need to go up or down from your initial setting. Roll the car back and forth to ensure the springs and shocks settle. Once you have measured your starting point set the vehicle on the ground. The front and rear often will not match each other. Match up both fronts to the same adjustment and then match up both rears to the same adjustment.

This has proven to give a better starting point for us personally. In this step we typically recommend measuring the exposed threads left on the coilover rather than your wheel gap or distance between fender and ground. This will ensure you can get a good starting point side to side. You’ll simply be using a measuring tape to dial it in. Get out the measuring tape.Īs mentioned, getting ride height set isn’t rocket science. For something getting a decent drop we typically opt for starting at the lower portion of the shock as that often leads to less adjusting after we’ve set it on the ground. Once you set the vehicle on the ground you can then get an idea if you need to go up or down based on where you start the spring height at. We have seen in many ways, but the two most popular starting points would be to start with the spring half way up the shock body or start with the spring at the bottom of the adjustment. We often get asked where do I even start once the coilovers are on. Let’s go over a few things that will help you get set-up and back on the road.

For those that are new to coilovers, an obvious question you may ask yourself is ”how do I make sure my ride height is set even?“ While there is no real science to it, there are some things to take into consideration and to keep in mind when adjusting the coilovers once installed.

Vehicle setup ride height vs. cross weight